This document is not restricted to specific software and hardware versions. There are no specific requirements for this document. Note: Not all DSL CPE modem/router products use the same DSL interface port pinouts. If the NID is installed by a Telco, the Telco must verify its functionality. The DSL cable between the Network Interface Device (NID)/wall jack/splitter and the Cisco DSL customer premises equipment (CPE) modem/router is the correct type. If you experience problems with the DSL connection on these devices, verify these : In this document, pinouts are named "port pinouts." Note: The terms "port pinouts" and "connector pinouts" are used interchangeably. This document describes the port pinouts and LED statuses for specific Cisco digital subscriber line (DSL) devices.
0 Comments
Leave a Reply. |